Mode Sense (10)
160 SL150 Interface Reference Manual Julyl 2017
Device Capabilities Page Definitions:
PS The Parameters Saveable bit is set to 0.
Page Code The Page Code field identifies the Device Capabilities mode page and always
contains a value of 1Fh.
Parameter Length This field indicates the amount of device capabilities data following this byte.
The library returns a value of 12h (18d).
StorDT This field identifies the ability of a tape drive to perform the function of
element storage.
The library returns a value of 1.
StorI/E This field identifies the ability of a mailslot cell to perform the function of
element storage.
The library returns a value of 1.
StorST This field identifies the ability of the cartridge tape storage cells to perform the
function of element storage.
The library returns a value of 1.
StorMT This field identifies the ability of the hand to perform the function of element
storage. The hand cannot be used as the source or destination of a move.
The library returns a value of 0.
MT -> DT This field identifies the support for the Move Medium command, where the
source is the hand, and the destination is a tape drive.
The library returns a value of 0.
MT -> I/E This field identifies the support for the Move Medium command, where the
source is the hand, and the destination is a mailslot cell.
The library returns a value of 0.
MT -> ST This field identifies the support for the Move Medium command, where the
source is the hand, and the destination is a cartridge tape storage cell.
The library returns a value of 0.
MT -> MT This field identifies the support for the Move Medium command, where both
the source and the destination is the hand.
The library returns a value of 0.
ST -> DT This field identifies the support for the Move Medium command, where the
source is a cartridge tape storage cell, and the destination is a tape drive.
The library returns a value of 1.
ST -> I/E This field identifies the support for the Move Medium command, where the
source is a cartridge tape storage cell, and the destination is a mailslot cell.
The library returns a value of 1.
ST -> ST This field identifies the support for the Move Medium command, where the
source is a cartridge tape storage cell, and the destination is a cartridge tape
storage cell.
The library returns a value of 1.
ST -> MT This field identifies the support for the Move Medium command, where the
source is a cartridge tape storage cell, and the destination is the hand.
The library returns a value of 0.
I/E -> DT This field identifies the support for the Move Medium command, where the
source is a mailslot cell, and the destination is a tape drive.
The library returns a value of 1.
To Next Page
Loading...
Need help?
General