Oracle storagetek sl150 Reference Manual

Log Sense
54 SL150 Interface Reference Manual Julyl 2017
TapeAlert Flags
TABLE 4-23 lists information about the TapeAlert flags. Flags are:
• in sequential order
• have valid values of 0 (off) or 1 (on)
• reports all 32
Type codes indicate:
• C = Critical
• W = Warning
• I = Informational
Informational Exceptions TapeAlert Page Definitions:
Parameter Code A 2-byte field which represents the TapeAlert Flag number.
DU Disable Update is always 0, which indicates that the target updates the log
parameter value instead of the initiator.
DS Disable Save is always 1, which indicates saving the log is not supported.
TSD Target Save Disable is always 0.
ETC Enable Threshold Comparison is always 0.
TMC Threshold Met Criteria is always 0.
LBIN The library returns 0 indicating it is not used.
LP List Parameter is always 0, which indicates the log parameter is a data counter.
Parameter Length Parameter Length is always 0x01. All are 1-byte flags.
Flag A value of 0x01 indicates that the flag the Parameter Code is pointed to is
active; all other values are off.
TABLE 4-23 TapeAlert Flags
Code Flag Name Type
0001h Media changer/data transfer device
communication fault. Set when the operator
removes a tape drive that has an assigned SCSI
Element Address. If the library is partitioned, the
tape alert is only set in the affected partition.
C
0002h Hardware Warning W
0003h Mechanical Hardware Fault C
0004h Hardware Fault C
0005h Diagnostics Requested I
0006h Host Interface Failure C
0007h Predictive Failure W
0008h Preventative Maintenance W
0009h Humidity Limits C
000Ah Temperature Limits C
000Bh Voltage Limits C

Oracle storagetek sl150 Specifications

General

Brand	Oracle
Model	storagetek sl150
Category	Storage
Language	English