Expander XX on network found.
Network Bell X on network lost.
Network Bell X on network found.
User walk test mode started.
User walk test mode ended.
An automatic test call was sent to the Alarm Receiving Centre (ARC).
A manual (user) test call was sent to the Alarm Receiving Centre (ARC).
Zone soak test has started and will run for XXX days.
Zone XX has failed whilst on test.
First activation from zone XX. The zone has the “Double Knock”
attribute.
First activation from zone XX. The zone has the “Beam Pair” attribute.
The user has disarmed the system within the abort delay period.
The bell tamper alarm has been activated.
The bell tamper has restored.
The Alarm Transmission System (ATS) has detected a fault with the
transmission path (telephone line/GSM/IP).
The ATS Fault has restored.
A panic alarm was generated at keypad X by pressing keys 7 and 9.
A fire alarm was generated at keypad X by pressing keys 1 and 3.
A medical alarm was generated at keypad X by pressing keys 4 and 6.
The control panel has detected a fault on panel output XX.
The fault on panel output XX has restored.
A cleaner access code has been entered.
A cleaner has logged off.
The communication module has been disconnected/lost from com port
X
The communication module has been connected/found from com port
X
Zone XX has reached the “Count Logging” threshold.
To Next Page
Loading...
