Orisec CT-10 - Emergency Keys

8
Status Icons
The system status area on the display is used to show the following information:
Status Icon
Indicates
#$%K
Battery is charging / is charged
L
Mains power is connected
&
Mains power is disconnected
p
External strobe is flashing
M
External bell is sounding
N
Chime is enabled
Q
Wi-Fi module connected
T
GSM module connected
H
Ethernet module connected
Z
Phone line connected
3
User programmed timer running
[
User programmed alarm running
Status LED
The keypad has a single multi-colour LED and is used to indicate the following:
Colour
System Status
Blue
Normal operation, all zones are healthy
Green
User menu selected and system is ready for arming
Yellow
One or more zones are active, system may not arm
Red
Alarm active
Emergency Keys
The keypad provides three different emergency functions. Depending on the setup of your
system, activation from these keys can alert the local police, key holders and security personal
via your Alarm Receiving Centre (ARC).
The emergency keys for each keypad can be individual enabled or disabled and may
not be enabled on your installation due to local standards and police requirements.
The Panic alarm (Police) function for each keypad can be programmed for either an
audible or silent operation.
Keyed Keypad Emergency Keys
To activate the emergency functions, press together the keys shown below for a duration of 1
second: