Otto Bock A200 - 8.11.3 Manually Elevating Legrests; Lap Belt System; 8.12.1 Lap Belt Adaptation

24
Adjusting the back support angle
1) Activate the release lever on the arm support (see
fig.24).
2) Move the back support to the desired position.
3) Let go of the release lever.
→ The back support is adjusted.
8.11.3 Manually elevating legrests
INFORMATION
► Please also observe the overriding safety instructions in the section "Manual seat functions" > "Safety instruc
tions": see Page37.
The mechanically elevating legrests with a gas compression spring let the user change the angle independently to
prevent a constant pressure load or to provide anti-shock support.
25
Pivoting the leg support
1) Activate the release lever on the leg support (see
arrow).
2) Move the leg support to the desired position.
3) Let go of the release lever.
→ The leg support is adjusted.
Installing/removing the leg support
1) To remove the leg support, pull it vertically out of
the adapter.
2) To install the leg support, insert it vertically into the
adapter and push it down.
8.12 Lap belt
The lap belt provides additional stabilisation and prevents the user from sliding out of the seat.
8.12.1 Adaptation
CAUTION
Improper adjustments
Injuries, malpositions, illness of the user due to adjustment changes
► The belt system is an important part of an individual seating unit/seating solution. Do not modify the installa
tion position and basic settings established by the qualified personnel.
► In case of problems with these adjustments (such as an unsatisfactory sitting position), promptly contact the
qualified personnel who fitted the product.
► Immediately consult the qualified personnel if you detect signs of discomfort or fear when using the product.
► Have the basic settings of the belt system checked regularly. Adjustments may be required due to the growth
of the user or because of changes in the course of the disease.
Small length adjustments of the belt by the user or an attendant (e.g.for clothing of different thickness) are pos
sible.
The belt length can be adjusted on both sides. Excess belt length is taken up by the plastic slider.
38
Use
A200