Otto Bock A200 - 8.16.2 Using Product in Vehicle

8.16.2 Using the product in a vehicle
WARNING
Positioning in vehicles for transporting persons with reduced mobility
Serious injuries in case of accidents due to user error
► Positioning of the product in vehicles for transporting persons with reduced mobility may only be performed
by the qualified personnel.
► The product must always face forwards when it is used as a seat in a vehicle for transporting persons with
reduced mobility.
► Instruct the qualified personnel regarding the mounting points on your product described below.
WARNING
Inadequate transportation safety
Loss of safe restraint due to failure to observe transportation instructions
► Observe the following instructions for correct transport safety in the vehicle for transporting persons with
reduced mobility.
► If necessary, instruct the qualified personnel on the following information.
Securing the product in the vehicle for transporting persons with reduced mobility
The wheelchair is secured in the vehicle for transporting persons with reduced mobility with the help of the fixation
kit. The fixation points are marked with stickers. The stickers indicate where the user has to engage the hooks of
the safety belt system:
41
Securing the power wheelchair in the vehicle
1) Position the power wheelchair in the vehicle for
transporting persons with reduced mobility. For
more information, refer to section 5 in the brochure
"Transporting persons with reduced mobility",
order number 646D158.
2) Turn the control device off (see Page27).
3) Verify brake locking. Engage the brakes if needed
(see Page30).
4) Apply the attachment straps (see below).
42
Applying the front attachment straps
1) Hook each of the front attachment straps into its
corresponding front anchor point from the outside
(see fig.42).
2) Tighten the front attachment straps.
47A200
Use