Otto Bock A200 - 8.16.3 Use Restrictions; Care and Cleaning; 8.17.1 Safety Instructions; 8.17.2 Cleaning Procedures

8.16.3 Restrictions for use
WARNING
Risk of accidents and injury due to using the product with certain settings and/or installed options
Severe injury in case of accidents due to options coming loose
► Before using the product as a seat in a vehicle for transporting persons with reduced mobility, remove options
that need to be taken off for safe transportation. Please observe the following table.
► Stow all dismantled components securely in the vehicle for transporting persons with reduced mobility.
► Please note that certain settings on the product exclude the use of the product in a vehicle for transporting
persons with reduced mobility.
Accessories* Transportation in a
vehicle for trans
porting persons
with reduced mobil
ity not possible
Remove option Secure option on
product
Head support with mounting kit X** X***
Tray, swing-away to the side X
Lap belt with buckle X****
Control panel holder, swing-away, height-
adjustable
X
* The following list provides an overview. Not all accessories are installed on all products.
** If the installed head support is not crash-tested, please remove the option.
*** The head support can remain on the power wheelchair if it is crash-test approved. Please refer to the order
form for the approved head supports.
**** The lap belt can be used to position the passenger during transportation. Using the personal restraint system
is nevertheless required.
8.17 Care
8.17.1 Safety instructions
CAUTION
Lack of or improper cleaning
Health hazard due to infections, damage to the product due to user error
► Clean the product at regular intervals.
► Water must not come into direct contact with the electronics, motor or batteries under any circumstances dur
ing cleaning. Never use a water jet or high-pressure cleaning apparatus to clean the product.
► To avoid contamination with germs, clean seat cushions and back support upholstery whenever they get
soiled.
► Check the driving behaviour of the product after cleaning it.
INFORMATION
Piston rods do not require lubrication. They are maintenance-free.
8.17.2 Cleaning
Clean the product regularly depending on the degree of soiling and frequency of use, at least 1xper month:
• Clean the control panel, battery charger, armrest and trim components with a damp cloth and mild cleaning
solution.
• Use a dry brush to clean the seat and back upholstery as well as the seat cushion.
• Use a damp plastic brush to clean the wheels and frame.
• Do not use any aggressive cleaners, solvents or hard brushes etc.
• Do not spray the product with a pressure washer.
• Observe additional cleaning instructions in the section "Lap belt": see Page38.
8.17.3 Disinfection
1) Thoroughly clean the pads before disinfecting.
2) Wipe all parts of the product with a disinfectant.
49A200
Use