Sets the frequency counter resolution. The allowed values are 1 Hz,
10 Hz, 100 Hz and 1 kHz. Changing the counter resolution can
change the counter accuracy. The higher the resolution, the higher
the counting accuracy.
5.6.2.5 [FIELD>]
After the antenna is connected, it is used to measure the field
strength of the air signal.
1) [FIELD On Off]
Open or close Filed measurement.
2) [Antenna Gain On Off]
Open or close Antenna Gain.
3) [UNIT]
Set filed measurement amplitude unit V ,dbuV，V/m，dbuV/m.
When Filed measurement is closed,unit V ,dbuV;
When Filed measurement is opening,unit V/m，dbuV/m.
4)[Antenna Set]
Enter Antenna Set submenu.
⚫Recall >
Recall antenna source,antenna 1 to antenna 6.
⚫New
Click to add new antenna factor.
⚫Delete
Click to delete antenna factor.
⚫Frequency
Set antenna factor frequency range.
⚫Factor
Set antenna factor parameters.
⚫Save
Save the set antenna factor parameters.
5.6.3【Marker→ >】
Key access:
[Marker] bottom softkey, and then [Marker→ >] right softkey
To Next Page
Loading...
