label..
5.6.4.3 [Next Peak]
Searches the peak whose amplitude is the closest to that of the
current peak. The peak is then identified with a marker. When this
key is pressed repeatedly, you can quickly find a lower peak.
5.6.4.4 [Left Peak]
Searches the nearest peak located to the left of the current marker.
The peak is then identified with a marker.
5.6.4.5 [Right Peak]
Searches the nearest peak located to the right of the current
marker. The peak is then identified with a marker.
5.6.4.6 [Cont Peak On Off]
Enables or disables the Cont Max search, the default is Off. When
enabled, the system will always execute a peak search
automatically .
5.6.4.7 [Peak Setup >]
Used to move the peak point to the Peak setup screen.
⚫ [Peak Excursion]
Set peak altitude.
⚫ [Peak Mode Max Min]
Set peak mode is max or min.
⚫ [Sort Freq Ampt]
Set the peak list to be sorted by frequency or amplitude.
⚫ [Peak List On Off]
Enable or disable the peak value list. When the peak list is opened,
the trace will display all the frequency markers that meet the peak
conditions in order, and below the trace color list of all the
frequency markers that meet the peak conditions.
⚫ [Return]
Return to the upper-level menu.
To Next Page
Loading...
