frequency at which the Delta Marker is located.
⚫The function is not available in zero span mode.
5.6.3.5 [Mkr→Ref Level]
Sets the reference level of the analyzer to the amplitude of the
current marker.
⚫ In Normal marker mode, the reference level will be set to the
amplitude of the current marker.
⚫ In Delta marker mode, the reference level will be set to the
amplitude at which the Delta Marker is located.
5.6.3.6 [MkrΔ→Span]
Sets the span of the analyzer to the frequency difference between
the two markers in Delta marker mode.
5.6.3.7 [MkrΔ→CF]
Sets the center frequency of the analyzer to the frequency
difference between the two markers in Delta marker mode.
5.6.4【Peak >】
Key access:
[Marker] bottom softkey → [Peak >] right softkey
Accesses the Peak setting menu.
Key Points:
The spurious signal at the zero frequency caused by LO feed
through is ignored.
5.6.4.1 [Max Peak]
Place a frequency marker at the highest point of the trace, and
display the frequency and amplitude of the marker in the upper
right corner of the screen.
5.6.4.2 [Peak-Peak]
Peak search and minimum search are performed at the same time,
and marked with "difference pair" frequency label, wherein peak
search results are marked with difference frequency label and
minimum search results are marked with reference frequency
To Next Page
Loading...
