Owon HSA1000 Series - Page 65

5.Menu Interpretation
59
⚫[Return]
Return to the upper-level menu.
b) [Deviation Axis >]
Set the deviation axis parameters.
⚫[Ref.Deviation]
Sets the reference offset position, expressed as a vertical
percentage.
⚫[Position]
Set the reference position of the waveform on the deviation axis.
⚫[Scale/Div Auto Man ]
Set each scale automatically or manually.
⚫[Return]
Return to the upper-level menu.
c) [AF Trigger >]
Set AF triggering conditions.
⚫[AF Trigger On Off]
Set AF trigger is open or close.
⚫[Edge Neg Pos]
Set positive edge or negative edge.
⚫[Trigger Mode]
Set trigger mode is single trigger or continue trigger.
⚫[Trigger Level]
Set trigger amplitude.
⚫[Trigger Delay]
Set trigger delay time.
⚫[Return]
Return to the upper-level menu.
4) [Date Reset]
Set the data reset of the maximum, minimum, and average values
of the FM modulated signal.
5) [Return]
Return to the upper-level menu.