and the horizontal time base of the waveform still can be adjusted
within a certain range, in other words, the signal can be expanded in
the horizontal or vertical direction.
When the horizontal time base is ≤50ms, the horizontal time base can
be expanded for 4 divisions downwards.
Single: Push this button you can set the trigger mode as single directly, so
when trigger occurs, acquire one waveform then stop.
Copy: You can save the waveform by just pushing the Copy panel button in
any user interface. The source wave and the storage location are
according to the settings of the Save function menu when the Type is
Wave. For more details, please see "Save Function Menu" on P65.
How to Print the Screen Image
To print an image of what appears on the oscilloscope screen, do as the
follows:
(1) Connect the printer to the USB Device port on the rear panel of the
oscilloscope.
Note: The USB Device port supports PictBridge compatible printers.
(2) Push the Utility button, select Function in the bottom menu, select
Output in the left menu.
(3) In the bottom menu, select Device as PICT. (When PC is selected, you
can get an image by Oscilloscope software.)
(4) In the bottom menu, select Print Setup. In the right menu, set up print
parameters. The On selection of Ink Saver will print out a copy with a
white background.
(5) Once you have connected a printer to your oscilloscope and set up print
parameters, you can print current screen images with a single push of the
Print button on the front panel.
To Next Page
Loading...
Need help?
General
