4. Advanced User Guidebook
Up till now, you have already been familiar with the basic operations of the function
areas, buttons and knobs in the front panel of the oscilloscope. Based the
introduction of the previous Chapter, the user should have an initial knowledge of
the determination of the change of the oscilloscope setting through observing the
status bar. If you have not been familiar with the above-mentioned operations and
methods yet, we advise you to read the section of Chapter 3 "Junior User
Guidebook".
This chapter will deal with the following topics mainly:
⚫ How to Set the Vertical System
⚫ How to Set the Horizontal System
⚫ How to Set the Trigger/Decoding System
⚫ How to Implement the Sampling Setup
⚫ How to Set the Display System
⚫ How to Save and Recall Waveform
⚫ How to Record/Playback Waveforms
⚫ How to Clone and Recall a waveform
⚫ How to Implement the Auxiliary System Function Setting
⚫ How to Update your Instrument Firmware
⚫ How to Measure Automatically
⚫ How to customize an automatic measurement
⚫ How to Measure with Cursors
⚫ How to Use Autoscale
⚫ How to Use Built-in Help
⚫ How to Use Executive Buttons
⚫ How to Print the Screen Image
It is recommended that you read this chapter carefully to get acquainted the
various measurement functions and other operation methods of the oscilloscope.
Note: The following operations and pictures are based on the four-channel
model. For the operation of the two-channel model, please refer to
the four-channel model.
To Next Page
Loading...
