Owon XDS4000 Series - 10. Technical Specifications; Oscilloscope

10.Technical Specifications
130
10. Technical Specifications
Unless otherwise specified, the technical specifications applied are for the oscilloscopes only,
and Probes attenuation set as 10X. Only if the oscilloscope fulfills the following two conditions
at first, these specification standards can be reached.
◼ This instrument should run for at least 30 minutes continuously under the
specified operating temperature.
◼ If change of the operating temperature is up to or exceeds 5℃, do a
"Self-calibration" procedure (see "How to Implement Self-calibration" on
P15).
All specification standards can be fulfilled, except one(s) marked with the word
"Typical".
Oscilloscope
Performance Characteristics
Instruction
Bandwidth
XDS4504
XDS4502
500 MHz
XDS4354
XDS4352
350 MHz
Vertical Resolution (A/D)
8 bits
Channel
XDS4502
XDS4352
2
XDS4504
XDS4354
4
Waveform Capture Rate
600,000 wfms/s
Multi-level Gray Scale Display &
Color Temperature Display
(Use gray scale to indicate frequency of
occurrence, where frequently occurring
waveform are bright.)
Support
Acquisition
Mode
Normal, Peak detect, Averaging
Sample rate
(real time)
Four CH
1 GSa/s
Dual CH*
2.5 GSa/s
Single CH
5 GSa/s
Input
Input coupling
DC, AC , Ground
Input impedance
1 MΩ±2%, in parallel with 15 pF±5 pF,
50Ω±2%
Input coupling
0.001X - 1000X, step by 1 – 2 - 5
Max input voltage
400 V (DC + AC Peak)
Bandwidth limit
20 MHz, full bandwidth