7. In the bottom menu, select Start again, the interfaces below will be
displayed in sequence. The update process will take up to three minutes.
After completion, the instrument will be shut down automatically.
8. Long press the
button to power on the instrument.
How to Measure Automatically
Push the Measure button to display the menu for the settings of the
Automatic Measurements. At most 8 types of measurements could be
displayed on the bottom left of the screen.
The oscilloscopes provide 39 parameters for auto measurement, including
Period, Frequency, Mean, PK-PK, RMS, Max, Min, Top, Base, Amplitude,
Overshoot, Preshoot, Rise Time, Fall Time, +PulseWidth, -PulseWidth,
+Duty Cycle, -Duty Cycle, Delay A→B , Delay A→B
,
Cycle RMS, Cursor
RMS, Screen Duty, FRR, FRF, FFR, FFF, LRR, LRF, LFR, LFF,Phase
A→B , Phase A→B , +PulseCount, -PulseCount, RiseEdgeCnt,
FallEdgeCnt, Area, and Cycle Area.
The "Automatic Measurements" menu is described as the following table:
To Next Page
Loading...
