Owon XDS4000 Series - How to Operate the Function Menu; How to Implement Sampling Setup

4.Advanced User Guidebook
60
Frame is not met, two red error marks will be displayed in the
corresponding position in the waveform.
⚫ Error Frame, Remote Frame, and Overload Frame will be identified in the
"Data" column in the event table (Data Frame will not be identified).
CAN Decoding menu list:
MENU
SETTING
INSTRUCTION
Bus
Type
CAN
Set bus type of decoding as CAN.
Display
Format
Binary
Decimal
Hex
ASCII
Set the display format of the bus.
EventTable
ON
OFF
Select "ON" to display the event table.
Save
EventTable
If a USB storage device is currently connected to
the instrument, save the event table data in a .csv
(spreadsheet) formatted file on the external USB
storage device.
ASCII Table
ON
OFF
Select "ON" to display the ASCII table.
How to Operate the Function Menu
The function menu control zone includes 8 function menu buttons: Measure,
Acquire, Utility, Cursor, Autoscale, Save, Display, Help and 3
immediate-execution buttons: Autoset, Run/Stop, Single.
How to Implement Sampling Setup
Push the Acquire button, Acqu Mode, Length and Intrpl is shown in the
bottom menu.
The description of the Acqu Mode menu is shown as follows:
Function Menu
Setting
Description
Acqu
Mode
Sample
Normal sampling mode.
Peak
Detect
Use to capture maximal and minimal
samples. Finding highest and lowest
points over adjacent intervals. It is used
for the detection of the jamming burr and
the possibility of reducing the confusion.