Owon XDS4000 Series - To Set Signals; To Output Sine Signals; To Set the Frequency

5.Use the Arbitrary Function Generator
101
To Set Signals
(1) Push button to show the bottom menu of generator.
(2) Select the desired waveform in the bottom menu, the corresponding menu is
displayed on the right.
(3) The parameters can be set in the right menu.
To Output Sine Signals
The parameters of Sine waveform in the right menu are: Frequency/Period, Start
Phase, Amplitude/High Level, Offset/Low Level.
To Set the Frequency
Select Frequency in the right menu (if Frequency is not displayed, select Period
and push it again to switch to Frequency). Set the parameter in the right menu,
see below.
Three methods to change the chosen parameter:
⚫ Turn the M knob to change the value of cursor position.
Press / direction key to move the cursor.
⚫ Use the input keyboard: Push the M knob, an input keyboard will pop up.
Turn the M knob to move between the keys. Push the M knob to input the
chosen key.
Units
Clear
OK