Owon XDS4000 Series - Touchscreen Operation

3.Junior User Guidebook
18
the amplitude of the trigger signal.
3. Push the Force button to force a trigger signal, which is mainly applied to
the "Normal" and "Single" trigger modes.
Touchscreen Controls
The LCD is touchscreen, you can control the oscilloscope by different gestures.
The touchable icon at the top right of the screen is used to enable ( ) or disable
( ) the touchscreen controls.
The instruction of touchscreen controls is as below.
⚫ Run/Stop: Click the or on the left top of the display area to run or stop
the waveform sampling.
⚫ Autoset: Click the on the left top of the display area to auto set.
⚫ Select a menu item: Touch the menu items in the bottom menu, or in the right
menu, or in the left menu.
⚫ Switch menu items: If there are options that can be switched on the menu,
you can repeatedly touch the area of the menu item to switch, or push the
corresponding button to switch. See figure below:
Press repeatedly to
switch the options
⚫ Adjust value on the menu item:
Click to increase the
value of cursor position
Move the cursor
Click to decrease the
value of cursor position
Click to show the
soft keyboard
⚫ Scroll the list: If there is a scroll bar in the left menu or in the file system
window, you can swipe up and down to scroll the list.
⚫ Touchable menu pane: Click the icon on the right bottom of the display
area, a shortcut menu will be shown. Click to enter the corresponding function
menu.