Owon XDS4000 Series - To Set the Period; To Set the Start Phase; To Set the Amplitude; To Set the Offset

5.Use the Arbitrary Function Generator
102
⚫ Use the touchscreen:
Click to increase the
value of cursor position
Move the cursor
Click to decrease the
value of cursor position
To Set the Period
Select Period in the right menu (if Period is not displayed, select Frequency and
select it again to switch to Period). Set the parameter in the right menu.
To Set the Start Phase
Select StartPhase in the right menu. Set the parameter in the right menu.
To Set the Amplitude
Select Amplitude in the right menu (if Amplitude is not displayed, select High
Level and select it again to switch to Amplitude). Set the parameter in the right
menu.
To Set the Offset
Select Offset in the right menu (if Offset is not displayed, select Low Level and
select it again to switch to Offset). Set the parameter in the right menu.
To Set the High Level
Select High Level in the right menu (if High Level is not displayed, select
Amplitude and select it again to switch to High Level). Set the parameter in the
right menu.
To Set the Low Level
Select Low Level in the right menu (if Low Level is not displayed, select Offset
and select it again to switch to Low Level). Set the parameter in the right menu.
To Output Square Signals
The parameters of Square waveform are: Frequency/Period, Start Phase,
Amplitude/High Level, Offset/Low Level.
To set the Frequency/Period, Start Phase, Amplitude/High Level, Offset/Low Level,
please refer to To Output Sine Signals on page 101.