Owon XDS4000 Series - Page 72

4.Advanced User Guidebook
66
Type
Wave
Configure
Image
Record
Clone
Choose the saving type.
About the Record type, see "How to
Record/Playback Waveforms" on P72.
About the Clone type, see “How to
Clone and Recall a waveform” on P76.
When the type is Wave, the menu shows as following:
Type
Wave
Format
(Right menu)
For internal storage, only BIN can be
selected. For external storage, the
format can be BIN, TXT or CSV.
Source
CH1
CH2
CH3
CH4
Math
(or MathFFT)
Check the waveform to be saved. (If
certain channel is off, the
corresponding menu item will be
disabled.)
Object &
Show
Objec
t
Wave0 to
Wave99
Choose the address which the
waveform is saved to or recall from.
Show
ON
OFF
Recall or close the waveform stored in
the current object address. When the
show is ON, if the current object
address has been used, the stored
waveform will be shown, the address
number and relevant information will be
displayed at the top left of the screen; if
the address is empty, it will prompt
"None is saved".
Close All
Close all the waveforms stored in the
object address.
Save
Save the waveform of the source to the
selected address. Whatever the Type
of save menu is set, you can save the
waveform by just pressing the Copy
panel button in any user interface.
Select Type in the bottom menu, in the
right Format menu, you can select the
storage format.
Storage
Internal
External
Save to internal storage or USB
storage. When External is selected,
save the waveform according to the
current record length (see "Record
Length menu" on P61); the file name is
editable. The BIN waveform file could
be open by waveform analysis software
(on the supplied CD).