160
Master display
F1. Front fog lights
This warning indicator is visible when the front fog lights are switched on.
F2. Not used
F3. MIL
This warning indicator is visible when the emission level is above the
legal limit or in case of a generic engine warning.
The function of this indicator is checked as follows:
– Contact on and the engine not running.
– The indicator lights up for 5 seconds, goes off for 10 seconds and on
again for 5 seconds. This is the so called bulb and system check.
– Then after 5 seconds the indicator starts to flash for 1 second with a
waiting period of 5 seconds.
– Any other flash pattern indicates a failure.
NOTE: During a trip and depending on the warning, the indicator flashes or
remains on to indicate a failure.
Consult a DAF Service dealer on how to read the flash pattern.
F4. High Exhaust System Temperature
This indicator is shown when:
– A regeneration is in progress and the exhaust gas temperature
reaches values which potentially can be harmful to bystanders or the
surrounding area and the vehicle speed is below a certain value.
– The exhaust gas temperature reaches values that can potentially be
harmful to bystanders or the surrounding area and
– The vehicle speed is below a certain value.
F5. Chassis not at normal driving height
This warning indicator is visible when the chassis is not at normal driving
height.
F6. Not used
F7. Trip reset button
Using this button the trip information is reset to zero.
DW63246305.book Page 160 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
