89
Instruments and controls
Lower side: Stop or inhibit regeneration, DPF
See section 'Regenerating DPF, Emission Aftertreatment System' in the
chapter 'Driving'.
A red indicator light in the switch indicates that the regeneration has
been stopped or inhibited.
Control panel location D
D.(1). Hill Start Aid
Press this switch to enable or disable the Hill Start Aid. When Hill Start
Aid is enabled the green indicator light in the switch is on.
See section 'Hill Start Aid' in the chapter 'Driver assist systems'.
D.(2). Depending on the version:
Normal driving height switch, air suspension
Briefly press this switch and the vehicle reaches its normal driving
height.
Second driving height switch
Press this switch to change the driving height.
This tumbler switch has two positions to regulate two different driving
heights, irrespective of the vehicle speed.
This function is optional and can be used if trailers are used with different
king pin heights.
Switch for exhausting tandem axle bellows (Australia and New
Zealand version only)
Press this switch to exhaust the tandem axle bellows. Briefly press this
switch once again and the vehicle reaches its normal driving height.
D.(3). ASR Anti Slip Regulation switch
Use this switch to increase the maximum permissible wheel slip. See
section 'Anti Slip Regulation' in the chapter 'Driver assist systems'.
D.(3). Depending on the version:
Off-road mode switch
Press this switch to engage or disengage the off-road mode of the
automated gearbox. For more information about driving in the off-road
mode, see section 'Off-road mode' in the chapter 'TraXon gearbox'.
DW63246305.book Page 89 Friday, March 22, 2019 4:54 PM
To Next Page
Loading...
