EasyManua.ls Logo

PACOM PDR960H-8HD - Figure 23: Event - Motion Setup Screen

PACOM PDR960H-8HD
102 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Digital Video Recorder
35
Figure 23 : Event – Motion setup screen.
Your DVR has built-in video motion detection. Video motion detection can be turned On or Off for each camera.
Highlighting the box under the Sensitivity heading and pressing the
button
allows you to adjust the DVR’s sensitivity to motion for Daytime and Nighttime
independently. There are five settings with 1 being the least sensitive and 5
being the most sensitive.
You can define the area of the image where you want to detect motion; e.g., a doorway. Highlight the box under the
Zone heading, and press the
button. The Motion Detection Zone screen displays.
The Motion Detection Zone screen is laid over the video for
the selected camera. You can set up motion detection zones
by selecting or clearing blocks.
NOTE: You can set up motion zones one block at a time in
groups of eight individual block groups. A block group is
positioned within the image area using the Up and Down
arrow buttons, and individual blocks within the block groups
are selected or cleared using the camera buttons.
Press the button to display the menu screen. The menu on the setup screen has the following functions:
Select — Activates highlighted blocks to detect motion.
Clear — Deactivates highlighted blocks so that they will not detect motion.
Reverse — Activates inactive highlighted blocks and deactivates active highlighted blocks.
Select All — Activates all blocks to detect motion.
Clear All — Deactivates all blocks so that they will not detect motion.
Reverse All — Activates inactive blocks and deactivates active blocks.
OK — Accepts changes and closes Zone setup.
Cancel — Exits Zone setup without saving changes.
You can adjust the minimum number of detection blocks that must be
activated to trigger a motion alarm. Highlighting the box under the Min.
Blocks heading and pressing the
button allows you to adjust the minimum
number of detection blocks for Daytime and Nighttime independently.
Smaller numbers provide greater sensitivity because fewer detection blocks
must be activated.

Table of Contents