1-8.
Timer
Playback
Connections
1.
2.
3.
4.
..........
Turn on the unit and insert a
recorded video cassette.
Set the EXT TIMER Selector to
"PLAY".
Press the RESET Button to reset
the tape counter to
"0:00:00".
Set
the timer.
[1]
Turn
on
the timer.
2
AG-7350
PLAY
E)
OFF
t
REC
EXT
TIMER
~ESET
MEMORY
~CJ
AG-7150
PLAY!sl
t
OFFU
EXT
TIMER
BEGIN
END
CJ
CJ
• Connection with video and audio cables
To
Audio
Input
(CH1)
r---------------------------------~~~~--~;__·~1
To
Audio
Input
(CH2)
r-------------------------------~~~----------~·
To Video
Input
r-------------------------------------~------·
0
~~mm
~mm~
~~Hm~
AC Power
Cord
TV
Monitor
To AC Outlet
AUDIO OUT
CH1/CH2
VIDEO OUT
1!::::::::::====:0
[0I@]
ACPoS?r
• Connection with S-VIDEO and
audio
cables
ToS-VIDEO
Output
Connector
To
Audio
Output(s)
5-VIDEO Cable
5.
When preset time comes
Clock
Timer
Cord
To 5-VIDEO
Input
Connector
To
Audio
Input
(CH1)
To
Audio
Input
(CH2)
ACPower
Cord
TV
Monitor
with
5-VIDEO
Input
Connector
To AC
Outlet
t======:::::()
[0I@] AC
Pow9
Clock
Timer
Cord
At the preset ON time, the unit will be turned
on
automatically to start playback. At the preset OFF time, the
unit
will be turned off, but the tape will remain loaded
on
the cylinder inside the unit.
• When the repeat function is set, the unit will rewind and then resume the repeat playback.
[2]
Set the timer
to
the desired ON and OFF time.
•
It
is
best
to
set the OFF time so that the unit
is
turned off about
10
minutes after the tape reaches its end. This
6.
will prevent the tape from damage.
If,
for example, NV-E180 tape is used for TIMER playback, the playback
time should be preset for about 190 minutes.
Press the STOP Button to stop
TIMER playback halfway.
STOP
~
• Refer to the operating instructions of the timer you are using for details.
Notes
• When the tape reaches its end, the unit will go into the mode set
in
the ON-SCREEN (initial setting) menu.
However, during repeat mode, the tape
will be automatically rewound.
•
If
the power
is
turned off while the tape is moving during TIMER playback, the tape will remain loaded
on
the
cylinder inside the unit. When the power is resumed, the unit will unload the tape from the cylinder. After a while,
the unit goes into the stop mode and then the TIMER playback mode.
OPERATING INSTRUCTIONS
To Next Page
Loading...
