Panasonic AG-7350 Series - Assembly Procedures of Loading Cam Gear and Retainer Gear; Assembly Procedures of Main Cam Gear and Pinch Speed down Gear

~
z
w
::E
~
en
::::)
..,
c
<C
..J
<C
0
z
<C
::I:
0
w
::E
4-4-2. ASSEMBLY PROCEDURES OF
SUB CAM GEAR,RING
GEAR AND
DETENT ARM
1 . Install the Ring Gear so that the two holes on the Ring
Gear align with the two holes on the chassis as shown
In Figure M48.
2. Install the Sub Cam Gear so that the large hole on Sub
Cam Gear aligns with the hole on chassis. Also the
small hole (located just outside of large hole) on Sub
Cam Gear should align with the hole on Ring Gear as
shown in Figure M48.
3. Confirm that the small hole on Sub Cam Gear is aligned
with the small hole on Connection Gear as shown in
Figure M46 (In case of the Connection Gear is already
installed).
4. Install the Detent Arm and make sure Detent Arm seats
perfectly in detent of Sub Cam Gear as shown in Figure
M48.
Capstan
~
Through
Hole
(Large Hole)
Small
Holes
C:i) _____ _,
Through Hole
(Ring Gear
'7/1--~-- "Wl.ll wdz
...,_~~. zn~~
Chassis
Detent Sub Cam
Arm Gear
Figure M48
4-4-3. ASSEMBLY PROCEDURES OF
MAIN CAM
GEAR AND PINCH 1
SPEED DOWN GEAR
1. Install the Main Cam Gear onto the Sub Cam Gear so
that the
small hole on the Main Cam Gear aligns with
small hole on the Ring Gear as shown In Figure M49.
2. Insert a retaining ring.
3. Install the Pinch Speed Down Gear from top side of
chassis so that
the small hole on the Main Cam Gear
aligns with small hole on the Pinch Speed Down Gear
as shown in Figure M49.
4-16
Pinch Speed Down Gear
. Retaining Ring Ring Gear
Mam Cam
Gear
Figure M49
4-4-4. ASSEMBLY PROCEDURES OF
LOADING CAM
GEAR AND
RETAINER GEAR
1 . Install the Retainer Gear onto the Ring Gear so that the
two holes
on the Retainer Gear align with the two holes
on the Ring Gear, at this time, small hole on the Main
Cam Gear should aligns with small hole on the Retainer
Gear as shown in Figure M50 .
2. Install the Loading Cam Gear so that the small hole
which is directly outside of the large hole on the Load-
ing Cam Gear is aligned with the outside hole of the
Retainer Gear as shown in Figure M50.
Gear
Through Holes
Retainer
Gear
Through
H:lrzzzzzz__- Retainer Gear
"lllliD I rz:zzm.- Ring Gear
~~ flli7T---chassis
Figure M50