Panasonic AG-7350 Series - Adjustment of the Capstan Thrust Gap

....
z
w
:::E
....
en
:::::)
..,
c
<
..J
<
(.)
z
<
:I:
(.)
w
:::E
4-3-3. ADJUSTMENT OF THE CAPSTAN
THRUST GAP
<<TOOL>>
Reel Table Height Gauge ; VFK0190
Height Adjustment Fixture ; VFK0344
<<SPEC>>
O.Smm +/- 0.05mm
1. Turn a Thrust Adjust Screw slightly until the capstan
rotor unit just touches the
coil of the capstan stator unit.
Figure M35
2. Unscrew 4 screws and remove the Gear Base Unit.
3. Set the Height Adjustment Fixture on the capstan Rotor
unit
as shown Figure M36.
Height Gage
Height Adj. Fixture
Figure M36
4-12
4. Adjust the Thrust Adjust screw so that the thrust gap be-
comes O.Smm +/- 0.05mm.
Height Gauge
Height Adj. Fixture
(_::J Thrust Adjust Screw
Figure M37