Panasonic AG-7350 Series - Height Adjustment of the Reel Tables

4-3-2. HEIGHT ADJUSTMENT OF THE
REEL
TABLES
<<TOOL>>
Post Adjustment Plate ; VFK0191
Reel Table Height Gauge ; VFK0190
<<SPEC>>
0- 0.15mm
1. Remove the cassette compartment.
2. Place the Post Adjustment Plate on the reel tables.
3. Place the Reel Table Height Gauge on the plate so that
the scraper of the gauge touches the cut-out portion of
the
plate, then set the gauge to zero 0 as shown in
Figure M30.
Figure M30
4. Measure the height of the top surface of either Reel
Table and note the difference in height from the plate
cut-out. (Figure
M30 and M31) Repeat this procedures
for the other
Reel Table.
VFK0190
VFK0191
Rael Table
Figure M31
5. If the difference of Supply Reel table is more than
0.15mm higher or lower, replace the Supply Reel table.
When the difference of Take Up Reel table is more than
0.15mm higher or lower, adjust nut (A) (Figure M32) so
that measurement becomes the spec. If you can not
adjust to the spec., replace Take Up
Reel table.
Nut (A)
Figure M32
Take Up
Reel Table
<<NOTE>>
When replacing the tables, the DD Reel Unit needs to be
removed from the chassis.
Remove 6 screws
and carefully lift it out as shown in Figure
M33.
Screws
DO Reel Unit
Figure M33 Bottom View of DD Reel Unit
<<NOTE>>
When assembling the DD Reel Unit, slide a Main Rod to far left
side
by rotating the Center Gear, and then screw the 6 screws.
...
Cut Washers
Figure M34
4-11
1-
z
w
:E
1-
0
:::)
..,
c
<C
..J
<C
0
z
<C
::1:
0
w
:E