Panasonic AG-7350 Series - Loading Motor Unit Maintenance Procedures; Main Brake (S), (T) Unit Maintenance Procedures; Reel Motor Unit Maintenance Procedures; Replacement of the Loading Motor Unit

w
()
z
<
z
w
1-
z
;;:
:E
3-4-6. REEL MOTOR UNIT MAINTENANCE
PROCEDURES
A. Replacement of the Reel Unit
1. Remove 6 screws (L) and carefully I ift the DO
Reel Unit.
2. Disconnect a connector.
Screws (L)
DD Reel
Connector
Figure M15
3. The Reel Motor Unit can be re-installed by
reversing
the rem ova I procedure.
*Note: When
assembling the DO Reel Motor
Unit, slide the Main Rod to far left
side by rotating a Center Gear.
...
Cut Washers
Figure M 16
3-8
3-4-7. MAIN BRAKE (S),(T) UNIT MAINTENANCE
PROCEDURES
A. Replacement of the Main Brake (S},(T) Unit
1. Remove the Reel Unit. (Refer to Reel Motor
Maintenance Procedures.)
2. Remove a Retaining Ring.
3. Remove the Main Brake (S),(T) with a spring.
Suplly Reel
Take-up Reel
Brake Solenoid Brake Spring
Figure M17
4. The new Main Brake (S), (T) Unit can be
reinstalled by reversing the removal procedure.
*Note: When
assembling the DO Reel Motor
Unit, slide the Main Rod to far left side
by rotating a Center Gear. (Figure M16)
3-4-8. LOADING MOTOR UNIT MAINTENANCE
PROCEDURES
A. Replacement of the Loading Motor Unit
1. Remove the Loading Belt.
2. Remove the Loading Motor Pulley.
3. Disconnect a connector.
4. Unscrew 2 screws (M) and remove the
Loading Motor Unit.
Screw {M) Loading Motor Unit
Loading
Motor Pulley
Ja-+--1
1
Connector Motor Base
C. B.A.
Figure M 18
5. The Loading Motor Unit can be reinstalled by
reversing the rem ova I procedure.