- 50 -
2 Touch / to adjust settings.
≥ You can select a value between s7 and r7.
3 Touch [EXIT] to complete the setting.
(Notes on Focus Assist)
≥ Focus Assist is not possible in following cases:
j During Recording Check (l 80)
j During Freeze Frame (l 81)
j When color bars are displayed. (l 95)
≥ Focus Assist is canceled in following cases:
j If you turn the unit off
j If you press the THUMBNAIL button
j When the setting of [FOCUS ASSIST] (l 48) is changed
j When EVF/LCD detail is enabled. (l 45)
j When you set this unit to Auto Focus
j When you press the USER button to which [FOCUS TRANSITION] is registered or touch the
applicable USER button icon (l 53)
j When [USB MODE SELECT] is set to [DEVICE] and this unit is connected to a PC. (l 122)
≥ The magnified display and peaking are not displayed on recorded images.
≥ The magnified display and peaking are not displayed on an external monitor.
≥ Freeze Frame is not available when you use Focus Assist. (l 81)
≥ Peaking may not be displayed when you use Digital Zoom (l 79). To zoom in and use peaking at
the same time, we recommend setting [FOCUS ASSIST] to [BOTH] and increasing the
magnification level of the magnified display.
(Notes on the magnified display of Focus Assist)
≥ Some information on the screen disappears when the screen is magnified.
≥ Still pictures cannot be recorded when the screen is magnified.
≥ In the following cases, the screen is not magnified during Focus Assist:
j During motion picture recording or PRE-REC (l 86, 163)
j When using Digital Zoom
j When using Area Mode (l 82)
j During auto recording (l 90)
j In Variable Frame Rate Mode (l 91)
≥ If
you
set the magnification level of the magnified display to 5.5k or higher, peaking may not be
displayed when using i.Zoom (l 41).
: [SW SETUP] # [PEAKING LEVEL] # desired setting
To Next Page
Loading...
