Getting started
VQT2J58
12
Auto Setup
5 Press [BACK/RETURN ] to confirm.
6 Enter the new PIN.
≥Make a note of PIN in case you forget it.
≥The default PIN is “0000”.
1 Select the number, then press [1].
2 Repeat step 1.
3 Press [OK] twice.
7 Set “Power Save” to “On”, “On Timer”
or “Off”, then press [OK].
≥Video from AV2 input cannot be viewed with
this unit in standby mode when Power Save in
Standby mode is activated.
When the following screen appears, Easy setting
is complete.
≥Select “Yes” to proceed to “Network Easy
Settings”. (> 13)
≥Select “No” to finish the Setup.
To stop partway
Press [BACK/RETURN ].
To restart set up
1 While stopped
Press [FUNCTION MENU].
2 Select “Others”, then press [OK].
3 Select “Setup”, then press [OK].
4 Select “Auto Setup” in “Tuning”, then press [OK].
To display the Owner ID information on TV
Press and hold [∫] on the main unit for more than
5 seconds.
The PIN is not displayed.
After 30 seconds this menu automatically disappears.
You cannot change the Owner ID on this screen.
You can perform this operation after step 6.
¾ To confirm the Channel List (> 76, Channel
List)
¾ To check the signal condition (> 77, Signal
Condition)
¾ To change PIN (> 86, PIN Entry)
¾ To sort the Channel List by region (> 76,
Channel Sorting by Region)
On Power consumption will be reduced
to a minimum level in standby
mode.
On
Timer
Set period of power save and then
press [OK].
≥Power Save in Standby mode is
activated at the set time period.
Off It is possible to start quickly from
the standby mode. (Quick Start
mode)
≥If you use Home Network (DLNA)
Function (> 66), select "Off". This
function is not available with other
settings.
RETURN
Enter a new 4-digit PIN, then press OK.
This PIN will be used for controlling viewing and playback.
PIN will be set to “0000” by pressing “RETURN” when there is no
number input.
0
-
Number
9
PIN Entry
- - - -
OK
RETURN
Power Save in Standby
Standby power consumption is reduced by disabling
Quick Start function and AV2 loop-through in standby.
Home Network (DLNA) function is not available in both standby
and power on modes
From To
Power Save
0
6
On
OK
Easy Setting
Easy Setting has been completed.
To use Internet functions, network connection needs
to be made first. Proceed Network Easy Settings ?
Select “Yes” to start. Select “No” to exit the Setup.
Yes No
DMRXW380EB-VQT2J58_eng.book 12 ページ ２０１０年４月８日 木曜日 午後３時５４分
To Next Page
Loading...
Need help?
General
