Getting started
VQT2J58
13
After completing “Easy setting”, you can continue with
“Network Easy Settings”.
Follow the on-screen instructions and make
the following settings.
≥Network connection test
≥Home Network (DLNA) function setting
≥Internet connection test
When TV picture appears, Setup is complete.
∫ When you experience problems with
settings
≥Network Easy Settings ( Connection Test )
≥Network Easy Settings ( Internet Connection
Test )
To stop partway
Press [BACK/RETURN ].
To restart Network Easy Settings
1 While stopped
Press [FUNCTION MENU].
2 Select “Others”, then press [OK].
3 Select “Setup”, then press [OK].
4 Select “Network Easy Settings” in “Network”, then
press [OK].
To redo settings individually
1 While stopped
Press [FUNCTION MENU].
2 Select “Others”, then press [OK].
3 Select “Setup”, then press [OK].
4 Select “Network Settings” in “Network”, then press
[OK].
5 Select “IP Address / DNS Settings” (> 84) or
“Proxy Server Settings” (> 84), then press [OK].
Check security before using Home Network
(DLNA) function
If you set “Home Network (DLNA) function” to “On”,
all connected devices on the same network can
access this unit. Ensure that the router for your home
network has adequate security system to prevent
unauthorized access.
≥Refer to the operating instructions of the hub or
router.
≥ Home Network (DLNA) function setting can not be set
when “Power Save in Standby” mode is activated.
≥ If you set “Home Network (DLNA) function” to “Off”, it is
possible to set to “On” later (> 67).
Network Easy Settings
Display
Check the
following
1. LAN cable
connection:
“Fail”
≥Connection of
the LAN
cables (> 10)
2. IP address
setting:
“Fail”
3. Connection to
gateway:
“Fail”
1. LAN cable
connection:
“Pass”
≥Connection
and settings of
the hub and
router
≥Settings of “IP
Address / DNS
Settings”
(> 84)
2. IP address
setting:
“Fail” or
“Home
network
available”
3. Connection to
gateway:
“Fail”
1. LAN cable
connection:
“Pass”
2. IP address
setting:
“Pass”
3. Connection to
gateway:
“Fail”
OK
RETURN
Network Easy Settings
LAN setup and testing of home network and
internet connections are required for internet
functions. Broadband Internet connection is
necessary for network features.
Please confirm that a LAN cable is connected.
Please refer to the operating instructions.
Press OK to start Network Easy Settings.
Display Check the following
Cannot find the
server. (B019)
≥Network connections and
settings
≥Settings of “IP Address /
DNS Settings” (> 84)
No connection
could be made to
the server. (B020)
≥The server may be busy or
the service may have been
suspended. Please wait a
few moments, and then try
again.
≥Settings of “Proxy Server
Settings” (> 84)
DMRXW380EB-VQT2J58_eng.book 13 ページ ２０１０年４月８日 木曜日 午後３時５４分
To Next Page
Loading...
Need help?
General
