Panasonic DP-1820P

368
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
(22) Using a 20 lb (80 g/m
2
) lined original, make a
copy from the ADF to check the feed alignment.
(23) Check the alignment of the Copy Image. If the
Copy Image is skewed either to the Right or Left,
adjust the ADF's alignment as follows:
a. Loosen 5 Screws securing the ADF.
b. Using the Hallmark on the Right Hinge Base
and the ADF Mounting Bracket as a guide,
shift the ADF position by following the
procedure below:
• When the Copy Image is skewed to the
right, shift the ADF slightly toward the
front of the machine.
• When the Copy Image is skewed to the
left, shift the ADF slightly toward the rear
of the machine.
c. Tighten the 5 Screws loosened in step (a).
d. Repeat step (22) to recheck the feed
alignment and readjust the ADF position as
needed.
(24) Install 2 Hinge Stoppers.
(25) Secure 2 Hinge Stoppers with 4 Screws
(XTB3+8J).
(26) Install 2 Hinge Covers.
Note:
When installing the Hinge Covers, make sure that
a Hinge Film is placed inside of each Hinge Cover.
Copy Image Leading Edge
< Example of Printed Image >
Skewed to
the right