Panasonic DP-1820P

367
SEP 2004
Ver. 1.2
DP-1520P/1820P/1820E
(11) Remove 10 Screws.
(12) Remove the Rear Cover.
(13) Remove the Protective Sheet.
(14) Bend the Protective Tab on the Rear Cover
approx. 180° towards the inside of the machine
as illustrated.
(15) Connect the i-ADF Harness to CN650 on the
SPC PC Board.
(16) Insert the Harness Clamp into the pre-drilled
hole in the frame (from underneath).
Note:
Do not cut the Harness Clamp (Tie-Wrap) when
servicing. Push the release clip on the side of the
clamp to remove it.
(17) Before proceeding, install the other options first.
If finished, close the i-ADF.
(18) Reinstall the Rear Cover.
(19) Secure the Rear Cover with 10 Screws.
(20) Plug the AC Power Cord and turn the Power
Switch on the Right Side of the machine to the
ON position.
(21) Reconnect the Telephone Line Cable if it was
disconnected.