Panasonic DP-8032 - Page 255

255
DP-8032/8025
2008Ver. 1.2
7.4.5. Internet Fax Function Confirmation
It is not necessary to set the parameter for the following suffix (Destinations). The Internet Fax Firmware is
automatically loaded with the Host Firmware.
PB : UK PG : Germany PM : Netherlands PK : China PT : Taiwan PU/PUG : USA
Note:
For other destinations below, set “00 FAX Service Mode : 01 Function Param. Setting :
#005 Destination Code” by following the steps below.
000 : Austria 001 : UK 002 : Canada 003 : Denmark
004 : Taiwan 005 : Finland 006 : Germany 007 : Netherlands
008 : Italy 009 : Spain 010 : Hong Kong 011 : Australia
012 : Switzerland 013 : Norway 015 : Portugal 016 : Ireland
017 : Belgium 018 : Sweden 019 : Turkey 020 : USA
021 : France 022 : New Zealand 025 : Japan 029 : Poland
030 : Czech 031 : Russia 032 : Greece 033 : Hungary
034 : Indonesia 035 : South Korea 038 : Malaysia 039 : China
045 : Thailand 048 : South Africa 049 : Singapore 050 : Universal
051 : East Euro
1. Press the “FUNCTION”, “ORIGINAL SIZE (LEDGER/A3)”, and the “3” keys simultaneously.
2. Input the Password, and select the “OK” button to enter the Service Mode (default password is
00000000).
3. Press the “9” key, and press the “START” key to enter the F9 Service Mode (Unit Maintenance).
4. Select “00 FAX Service Mode”.
5. Select “01 Function Param. Setting”.
6. Select the “” button, and select “005 Destination Code”.
7. Select the “CHANGE” button.
8. Input the new Destination Code, and Select the “OK” button twice.
9. Select the “” button, and select “06 RAM Initialize”.
10. Select “01 Parameter Initialize”, and select the “YES” button.
11. Press the “STOP” key.
12. Press the “FUNCTION” and the “C (CLEAR)” keys simultaneously to exit the Service Mode.
13. Turn the Power Switch on the Left side of the machine to the OFF, and back to the ON position to
enable the parameter settings.
Note:
If the desired Language is not showed on the LCD Display, proceed the steps 7.4.3. : 1. ~ 7. & 11.
again.
7.4.6. User Authentication, and/or Via Fax Server Function Confirmation
(Specified Destinations only)
If your customer requires User Authentication, and/or Via Fax Server Function, setup the feature(s) by
referring to the Operating Instructions (For User Authentication) for the PU/PUG (USA/Canada, etc.).
Note:
For the other destinations below, set “00 FAX Service Mode : 01 Function Param. Setting :
#005 Destination Code” by following steps.
000 : Austria 001 : UK 006 : Germany 009 : Spain
011 : Australia 021 : France 022 : New Zealand
1. Press the “FUNCTION”, “ORIGINAL SIZE (LEDGER/A3)”, and the “3” keys simultaneously.
2. Input the Password, and select the “OK” button to enter the Service Mode (default password is
00000000).
3. Press the “9” key, and press the “START” key to enter the F9 Service Mode (Unit Maintenance).