268
DP-8032/8025
2008Ver.1.2
(24) Remove the Blind Label.
(25) Install the Speaker as illustrated.
(26) Secure the Speaker with 2 Screws.
(27) Connect the Speaker Harness to the SW3C
Harness.
(28) Insert the Speaker Harness into the Harness Clamp.
(29) Reinstall the Front Left Cover, the Process Unit and
Toner Waste Container.
(30) Attach the Type Approval Label (specified
destination) to the Lower Rear Cover as illustrated.
(31) Proceed with the installation of other options. If
finished, reinstall all Harnesses and Covers.
(32) Connect one end of the Telephone Line Cable to the
LINE Jack on the left side of the machine, and the
other end to the RJ-11C Jack on the wall.
(33) Plug the AC Power Cord, and turn the Main Power
Switch on the Back and the Power Switch on the Left
Side of the machine to the ON position.
(34) Reconnect the LAN Cable if disconnected.
(35) It is not necessary to set the parameter for the following suffix (Destinations). The Fax Firmware is
automatically loaded with the Host Firmware.
PB : UK PG : Germany PM : Netherlands PK : China PT : Taiwan PU/PUG : USA
Note:
For other destinations, set the “00 FAX Service Mode : 01 Function Param. Setting :
#005 Destination Code”.
000 : Austria 001 : UK 002 : Canada 003 : Denmark
004 : Taiwan 005 : Finland 006 : Germany 007 : Netherlands
008 : Italy 009 : Spain 010 : Hong Kong 011 : Australia
012 : Switzerland 013 : Norway 015 : Portugal 016 : Ireland
017 : Belgium 018 : Sweden 019 : Turkey 020 : USA
021 : France 022 : New Zealand 025 : Japan 029 : Poland
030 : Czech 031 : Russia 032 : Greece 033 : Hungary
034 : Indonesia 035 : South Korea 038 : Malaysia 039 : China
045 : Thailand 048 : South Africa 049 : Singapore 050 : Universal
051 : East Euro
To Next Page
Loading...
