274
DP-8032/8025
2008Ver.1.2
(8) Install 3 Harness Clamps (Small) to the Rear Cover.
(9) Secure the HDD2 Harness with the 2 Harness
Clamps.
(10) Secure the DC12 Harness with the 4 Harness
Clamps.
(11) Route the DC12 Harness through the access hole in
the side frame.
(12) Remove 2 Shoulder Silver Screws (Upper) and 2
Silver Screws (Lower).
(13) Remove the Left Cover.
(14) Remove 2 Screws.
(15) Open the LVPS Cover.
(16) Connect the DC12 Harness on the DC PC Board
(CN145).
(17) Secure the DC12 Harness with the 2 Harness
Clamps.
To Next Page