Panasonic DP-8032 - Page 275

275
DP-8032/8025
2008Ver. 1.2
(18) Install the HDD into the HDD Bracket.
(19) Secure the HDD Bracket with 4 Screws (A) from
bottom (6-32 x 3/8).
(20) Secure the HDD Bracket with 6 Screws (B) from side
(6-32 x 3/8).
Caution:
Exercise care to prevent the HDD from Shock, and
Vibration damage.
(21) Connect the HDD2 Harness to the HDD.
(22) Remove 1 Screw from the machine.
(23) Secure the Ground Harness with 1 Screw removed
in step (22).
(24) Install the HDD Assembly onto the Rear Cover.
(25) Secure the HDD Assembly and the Ground
Harness with 2 Screws (M3 x 6).
Caution:
Exercise caution not to pinch the wires under the
HDD Assembly.
Caution:
Exercise care to prevent the HDD from Shock, and
Vibration damage.
Caution:
Connect the Connector on the short shield side of the
HD Harness to the HDD as illustrated.
Caution:
Make sure that the HD Harness is connected to the
HDD correctly as illustrated.
(26) Remove 1 Screw from the machine.
(27) Connect one end of the HD Harness to CN59 on the
SC PC Board.
(28) Secure the HD Harness with the Harness Clamp
(Metal) and 1 Screw (M3 x 8).
Short Shield
SC
To
PCB
HDD
Shield
Key
Tape
(Black)