294
DP-8032/8025
2008Ver.1.2
8.14. Installing the 1-Bin Finisher (DA-FS300)
8.14.1. Contents
Note:
1. The part number may differ depending on the Destination.
2. Refer to the Parts List in the Parts Manual.
3. Before you begin the installation of your 1 Bin Finisher (DA-FS300), read these entire instructions.
8.14.2. Installation
CAUTION!
Turn the Power Switch on the Left Side, and the Main Power Switch on the Back of the
machine to the OFF position, and then unplug the AC Power Cord before beginning
installation.
Qty. Description Remarks
1 1-Bin Finisher
1 Finisher Tray Assembly
1 Base Bracket
1 Front Slide Guide Bracket
1 Rear Slide Guide Bracket
1 IPC PC Board
1 Optional LVPS
For USA and Canada
For EU and Other Destinations
1 FNS Harness
1 LVS2 Harness
2 Snap Ring
4 Thumb Screw (Silver)
7Screw
1 Installation Instructions This document
Note:
Make sure that there will be adequate space for
working area (i.e., removal of paper).
3.94 in (100 mm)
3.94 in
(100 mm)
3.94 in
(100 mm)
3.94 in
(100 mm)
51.65 in
(1312 mm)
71.06 in
(1805 mm)
To Next Page
Loading...
