295
DP-8032/8025
2008Ver. 1.2
(1) Open the Right Cover.
(2) Remove 2 Silver Screws.
(3) Remove the Right Rear Cover.
(4) Remove 2 Silver Screws.
(5) Remove the Lower Rear Cover.
Caution:
The OPC Drum is sensitive to light. To prevent optical
exposure problems, do not expose the OPC Drum to
direct sunlight or bright light (even if it is a 1000-Lux
fluorescent lamp).
(6) Cut off the Protective Tab on the Rear Cover.
(7) Remove 1 Screw.
(8) Remove the Access Plate.
(9) Remove 2 Screws.
(10) Remove the HP Cover.
(11) Install the Connector of the FNS Harness to the HP
Cover.
(12) Secure the Connector with 2 Screws (XTW3+6LFC).
To Next Page