296
DP-8032/8025
2008Ver.1.2
(13) Secure the Ground Harness with 1 Screw
(XTW3+6LFC).
(14) Reinstall the HP Cover.
(15) Secure the HP Cover with 2 Screws.
(16) Connect one Harness to Intermediate Connector.
(17) Route the FNS Harness through the upper hole to the
main PC Board area.
(18) Remove 4 Silver Screws.
(19) Open the Rear Cover.
Caution:
If the LEDs on the SC and SPC PC Boards are lit
(ON), the Power to the machine is still ON.
Please read ā8.14.2. Installation : CAUTION!ā once
again.
To Next Page