305
DP-8032/8025
2008Ver. 1.2
8.17.2. Installation
Caution:
The DP-8032 series has been described as an example of the representative.
Refer to each service manual for other models.
CAUTION!
Turn the Power Switch on the Left Side and the Main Power Switch on the Back of the machine
to the OFF position, and then unplug the AC Power Cord before beginning installation.
(1) Install the 2 ADF Mounting Brackets, and push
down as illustrated.
(2) Secure the 2 ADF Mounting Brackets with 8 Screws
(Long).
(3) Install 2 Thumb Screws, one on each ADF
Mounting Bracket.
Note:
When installing the 2 Thumb Screws, do NOT tighten
the Screws. Keep about 6-8mm space as illustrated.
(4) Install the i-ADF / ADF on top of the ADF Mounting
Brackets.
Note:
1. Set the i-ADF / ADF in the direction of the arrow.
2. Align the hallmark on the right side of the Hinge
Base and the ADF Mounting Bracket as illustrated.
(5) Install 2 Hinge Cover 2.
(6) Secure the i-ADF / ADF with 2 Screws (Middle).
(7) Tighten the 2 Thumb Screws.
(8) Install 1 Screw (Short) on the back of the left ADF
Mounting Bracket from the bottom.
Screws
(Long)
Screws
(Long)
ADF Mounting BracketsADF Mounting Brackets
6~8mm
Thumb ScrewsThumb Screws
Thumb Screw
Hinge Base
Screw
(Middle)
Hinge
Cover 2
Screw
(Short)
To Next Page
Loading...
