355
DP-8032/8025
2008Ver. 1.2
(6) Remove 1 Screw (2521).
(7) Remove the Rear Cover Assembly (2605).
Note:
When reinstalling the Cover, make sure 2 Latch
Hooks are in the holes.
<Removing Finisher Tray Cover Assembly>
(8) Remove 2 Screws (2521).
(9) Remove the Tray Assembly (2515).
<Removing Finisher Controller PC Board>
(10) Remove 2 Screws (2632) and 2 Washers (2634).
(11) Remove the Right Cover (2604).
(12) Lift the PCB Cover Mylar (2635) up.
To Next Page
Loading...
