Panasonic DP-8032 - Page 41

41
DP-8032/8025
2008Ver. 1.2
(15) Remove the Snap Ring (S9).
(16) Remove the Pin (744).
(17) Remove the ADF Shaft (1724).
(18) Remove the ADF Roller (1728).
(19) Remove the Snap Ring (S9).
(20) Remove the Pre-Feed Roller Shaft (1730).
(21) Remove the Pre-Feed Roller (1731).
(22) Remove 1 Silver Screw (B1).
(23) Remove the ADF Front Cover (1637).
Note:
Release 3 Latch Hooks in alphabetical order and in
the direction as shown by each arrow.
(24) Remove 4 Screws (19).
(25) Remove the Upper ADF Guide (1723).
(26) Remove the Snap Ring (S9).
(27) Remove the Torque Limiter Bushing (1741) and
Torque Limiter Spring (1742).
Note:
When reinstalling the Torque Limiter Assembly,
ensure that the Torque Limiter Spring is placed into
the deeper slot of the Separation Roller.
(28) Remove the Separation Roller (1740).
(29) Disconnect the APNT Harness (1956) and remove
Sensor (1045) (Original Detection Sensor).