48
DP-8032/8025
2008Ver. 1.2
(6) Remove 4 Screws (19).
(7) Remove the F/R Scanner Frame (240).
(8) Remove 2 Screws (19).
(9) Remove the 2 Lamp Plate Springs (232).
(10) Disconnect the Harness on the LFB PC Board
(CN181).
(11) Remove the Scanning Lamp (204).
(12) Remove 2 Mirror Plate Springs (230).
(13) Remove Mirror 1 (264).
Note:
Observe the position of the Mirror 1 before removing
it. The Black Mark on the Mirror, indicates non-
reflective side. When reinstalling, make sure the
smooth side of Mirror 1 with the Black Mark is pointing
downwards.
(14) Disconnect 2 Harnesses on the Inverter PC Board
(CN1 and CN2).
(15) Remove 1 Screw (19).
(16) Remove the Inverter Upper Cover (212).
To Next Page
Loading...
