Panasonic DP-8032 - Page 49

49
DP-8032/8025
2008Ver. 1.2
(17) Remove 2 Screws (19).
(18) Remove the Inverter PC Board (268).
(19) Remove 2 Red Screws (D24).
(20) Remove the FPC Cable Holder A (215) Assembly.
(21) Holding by the center, slowly move the Lamp Base
Assembly towards the left of the Scanner Base
Frame.
(22) Disconnect the Harness on the LFB PC Board
(CN181).
(23) Remove 1 Screw (19).
(24) Remove the FPC Cable Holder B (216) Assembly.
(25) Remove 2 Sliders on the Connectors.
(26) Remove the FPC Cable (260).
Note:
The Sliders must be reinstalled when reassembling.