65
DP-8032/8025
2008Ver. 1.2
<Fuser Lamps Handling Precautions>
Note:
1. When reinstalling, route the Harnesses along the
hooks as illustrated.
2. Be sure to install the longer Harness to the Gear
side and the shorter Harness to the other side.
3. Make sure that the 600W Fuser Lamp (White
Harness) is plugged into the upper left slot and the
450W Fuser Lamp (Red Harness) is plugged into
the lower right slot.
4. Route the Harnesses (White, Black and Red) along
the 3 hooks as illustrated.
5. Do not touch the glass portion of the Fuser Lamp
with bare hands. Grease from the fingerprints will
shorten its life cycle, use a soft cloth, saturated with
isopropyl alcohol to clean fingerprints.
6. Use care when handling the Fuser Lamps to avoid
breakage.
(42) Remove 2 Screws (21).
(43) Remove the Front and Rear Roller Holders (1056
and 1057).
(44) Remove the Fuser Roller (1026) Assembly.
To Next Page
Loading...
