Panasonic DP-8032 - Page 66

66
DP-8032/8025
2008Ver. 1.2
(45) Remove the 2 C-Rings (1078).
(46) Remove the E40 Heat Roller Gear (1014).
(47) Remove the Plate Spacer (1023).
(48) Remove the 2 Insulation Bushings (1006).
(49) Remove the 2 Bearings (1046).
Note:
1. The Plate Spacer is installed only to the non-Gear
side.
2. Do not scratch the surface of the Fuser Roller when
removing or reinstalling it.
<Cleaning Insulation Bushings>
Clean the Insulation Bushings with a soft cloth, saturated
with isopropyl alcohol.
<Cleaning Fuser Roller>
Clean the surface of the Fuser Roller with a soft cloth,
saturated with isopropyl alcohol.
(50) Disconnect the Harness.
(51) Remove 2 Screws (23).
(52) Remove the Upper Fuser Cover (1002).
(53) Remove the Exit Roller (1028).
(54) Remove the Turn Guide (1007).
(55) Remove 1 Screw (19).
(56) Remove the Upper Guide (1001).