Difference in Specifications Between FP-X0 Models
The following tables show the main differences between each FP-X0 models. Check those differences
thoroughly before use.
Comparison of hardware specifications
Service power supply for
input
None 24V DC 0.3 A 24V DC 0.3 A 24V DC 0.3 A
No. of
controllable
I/O points
Control
unit
14 points
DC input: 8
Relay output: 4
Tr. output: 2
30 points
DC input: 16
Relay output: 10
Tr. output: 4
40 points
DC input: 24
Relay output: 12
Tr. output: 4
60 points
DC input: 32
Relay output: 24
Tr. output: 4
Max. 3 units
(Max. 90 points for expansion units)
One of the followings can be input
to the terminal block of the control
unit or they can be connected in
combination.
(1) Connect potentiometer.
(2) Connect thermister.
(3) Input voltage 0 to 10V.
Clock/calendar function
(Realtime clock)
None Built in
Backup battery Cannot be installed.
Can be installed.
(1) Operation memory can be set
whether to be held or not by system
registers.
(2) Clock/calendar (realtime clock)
Internal relay: 80 points,
Internal relay: 128 points,
Comparison of communication interfaces
Usable function
- MEWTOCOL-slave
(L14/L30: 118 bytes/frame)
- (L40/L60: 2k bytes/frame)
- General-purpose serial
communication
-
- MEWTOCOL-slave
(2k bytes/frame)
- General-purpose serial
communication
- Modem Initialization
COM
port
Usable function None
- MEWTOCOL-(master/slave)
(2k bytes/frame)
- General-purpose communication
- MODBUS RTU (master/slave)
- PLC link
-
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com