z Format
Format
For [60Hz]
2160/60p, 1080/60p
For [59.94Hz]
2160/59.94p, 2160/29.97p, 1080/119.88p, 1080/59.94p, 1080/29.97p,
720/59.94p
For [50Hz]
2160/50p, 2160/25p, 1080/100p, 1080/50p, 1080/25p, 720/50p
For [24Hz]
2160/24p, 1080/24p
For [23.98Hz]
2160/23.98p, 1080/23.98p
The video format is changed on this screen.
The setting is confirmed with the [Set] button.
<NOTE>
• Streaming stops when changing the system format.
• For details on how to change the format, refer to “Changing the
format” (→ page 51).
• In order to select [H.264(UHD)], [H.265(UHD)], [JPEG(UHD)],
[RTMP(UHD)], [SRT(H.264 UHD)], and [SRT(H.265 UHD)] in
[Streaming mode] for [Video over IP], you need to select the 4K
format here.
z SFP+ Mode
Set the operating mode for the SFP+ connector.
SFP+ Mode [12G Output, ST2110]
12G Output The same video signal is output as the video output from
the 12G SDI OUT connector.
ST2110 Video/Audio data that conforms with SMPTE ST2110 is
output.
Factory settings: 12G Output
<NOTE>
• This unit automatically restarts when [SFP+ Mode] is changed.
• The following functions cannot be used when [12G Output] is
selected:
- SMPTE ST2110 video/audio output.
- SMPTE ST2110 video input (RETURN) (→ page 136)
- PTP synchronizing (→ page 138)
z V‑LOG
The setting is confirmed with the [Set] button.
V‑LOG [Off, On]
Set the V-LOG mode.
Off This setting allows detailed picture quality adjustments on
the camera.
On Set a gamma curve that provides broad tones and a wide
range of latitude (exposure range).
Grading will be necessary after shooting.
Factory settings: Off
<NOTE>
• This cannot be set when the [Basic Config] – [HDR] is [On].
• Functions to adjust picture quality are limited when [Basic Config] –
[V-LOG] is [On].
V‑LOG PAINT SW [Off, On]
Selects whether to make it possible to make settings in the [PAINT]
menu when [Basic Config] – [V-LOG] is [On].
Factory settings: Off
<NOTE>
• This cannot be set when the [Basic Config]
– [V-LOG] is [Off].
z HDR
HDR [On, Off]
Enables/disables the HDR mode.
The setting is confirmed with the [Set] button.
Factory settings: Off
<NOTE>
• This cannot be set when the [Basic Config] – [V-LOG] is [On].
113
Web screen configurations (continued)
To Next Page
Loading...
