Select the unit (or units) to be operated from the wireless remote control
or controller.
Even when using only one unit, it must still be selected.
Set in [WIRELESS ID] from the OSD menu of this unit.(→ page 32)
When performing operations from a wireless
remote control
Up to four units can be operated using one wireless remote control.
1. Press the CAMERA<1>, <2>, <3>, or <4> button.
The unit’s status display lamp blinks green when a signal matched by
the remote control ID has been received, and it blinks orange when a
signal that is not matched by the remote control ID has been received.
When performing operations from a controller
When using an AW‑RP150 or AW‑RP60
For details, refer to the operating instructions for the controller.
• Network connection with AW-RP150 or AW-RP60 requires setup of an
initial account. (→ page 34)
When an initial account is not set up, AW-RP150 or AW-RP60 can
detect but cannot control this unit.
• When operating the camera on a network with a controller, such as the
AW-RP150 or AW-RP60, and [SERIAL] or [IP] of [TRACKING DATA
OUTPUT] is set to [ON], the tracking data output may be delayed or
the value may not be updated. (→ page 71)
Selecting the units
38
To Next Page
Loading...
